Redefining Failed Features
When a Datum Feature, let's say a datum plane, fails due to a missing reference, I am presented with the definition dialogue box, in which the failed/missing references are highlighted with a little red dot.
What Should Happen:
I click on a reference of the same type as the failed/missing reference and click OK. The object regenerates without a problem.
What Actually Happens:
I click on a reference of the same type as the failed/missing reference and the remaining good reference(s) are removed from the dialogue box. I curse, click Cancel and try to remember/write down the good references in case it happens again.
I try again, Right-Click, Remove the failed/missing reference, press and hold CTRL, click on a reference of the same type as the failed/missing reference and click OK. The object regenerates without a problem.
The software knows what is wrong, it knows what reference it requires, it knows which reference has failed. Why, then, does it not accept the first appropriate click I make as the replacement reference and just work?
Just one more instance of unfinished/badly-thought-out interface software, I am afraid
WF4, M220
I hope this has all been fixed in C2, M050, but...
