Skip to main content
Aug 28, 2012 9:10 AM UTC
Delivered

Redefine a master rep general view and convert it in a simplified rep view for a PART drawing

Related products:Creo Parametric

Redefine (and not DELETE and RECREATE) a master rep general view and CONVERT it in a simplified rep view for a PART drawing.

17 replies

Mar 1, 2017 2:12 PM UTC

Thanks for the response Raphael!!!

Jun 14, 2018 7:07 PM UTC
Status changed to: Acknowledged
Jun 29, 2020 9:30 AM UTC
Status changed to: Current Functionality

Updating the status per my predecessor's notes in the past (Raphael).

The below mentioned functionality "Replace View Model" that was introduced with Creo 4.0,  now allows to replace a Master rep that is applied to some drawing views by other Simplified Rep of that part

Oct 28, 2022 10:00 PM UTC

@RaphaelCNascime , @Mfridman ,

 

This is beautiful!  I tested in Creo7 and it seems to work perfectly well!  Thank you!

 

This looks like it give us the ability to switch methods from the unsupported asm merge feature (not MBD or Windchill friendly) to Simplified Reps with far less pain and hours of work.

 

Lawrence

olivierlp
Community Manager
Oct 31, 2022 2:29 PM UTC
Status changed to: Delivered

Changing the status to reflect the chronology: the idea was posted in 2012 and Creo released in Dec 2016. 

Olivier
Apr 16, 2025 7:49 PM UTC

Creo 8: Well, ain't this peachy. Got a large assembly in a couple different configurations/Reps (some parts not used in certain Reps), and if you create the dwg view using a Rep, but then change the Rep at the assembly level, the BOM will change but the dwg view WILL NOT. Replacing the Rep for that view, or everything else I tried, DO NOT WORK. The only thing that worked was DELETING the view, and putting a new General view in it's place. Nice, especially since it's a large assembly with a bunch of sheets. So, my "Pro/WORKAROUND" is to NOT make dwg views until you are 100% sure the Reps won't change.

 

Must be all that "Enhanced Functionality" PTC keeps crowing about when they waste time giving us confusing new interfaces, but spend zero time fixing bugs...you know, like that "split cylinder" BUG, or the one where threads don't show up in the model except in wireframe viewing mode, or.......

Jul 10, 2025 12:50 PM UTC

Hello everyone, as others, i'm here because everytime i change the representation on an view, i have to redo completely te balloons placement. It's a huge waste of time, when the representation only vary of a few components (often simply turned off). I can't really believe that this was not taken in consideration. Also, it's confusing because you change the view, you try to change the view with a family table memeber, but Creo does not let you redo the ballons because "it's not a valid view". BUT IF YOU CANCEL AND REPLACE THE SAME TABLE... magically you can do the ballons again, but the numbers are not the same as before and I have to order them again because it's a chaos. 

For sure there is a CREO typical confused counterintuitive non-euclidean way to swap the views keeping the ballons, but i did not find any clue as today.