Skip to main content
Mar 22, 2016 6:55 PM UTC
Archived

Provide feedback on model when using 2D CoPilot

Related products:Creo Parametric

When using the commands which use the 2D CoPilot and catching points on a 3D model, the edges and vertices on the model are projected as temporary construction geometry on the active workplane. But if the workplane is off of the part, it is not obvious if you are selecting the right edge or vertex.

2D_CoPilot_snap.jpg

But with the old, "classic" commands there was feedback on the model, so there was no question.

2D_CoPilot_snap_classic.jpg

1 reply

olivierlp
Community Manager
Jan 4, 2022 3:51 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier