Skip to main content
May 21, 2025 11:21 AM UTC
Acknowledged

Planar cross section throug an axis or a point

Related products:Creo Parametric

1. Describe the Problem

It would be useful if in the 'planar section' command it were possible to select multiple references sufficient to identify a plane, such as 3 points, 2 coplanar axes, 1 axis and a plane with a parallelism/orthogonality constraint. This way, there would be no need to create a plane on the fly, which is then placed outside. Alternatively: making sure that the 3D dragger remains attached to that axis or point even after modifications.


2. Are you using a workaround?
1. Create a plane ad use it for cross section. 2. Use offset cross section

3. What is the use case for your organization?
When we want to create a section through an axis off a hole.

4. What impact does this problem currently have on your organization?
Greater chance of errors in the sections on the drawings, which should cut a hole in half but have not been updated following some changes.

4 replies

Community Manager
May 21, 2025 2:59 PM UTC
Status changed to: Clarification Needed

Thank you @Francesco_P for publishing your idea. However, I'd like to suggest adding screenshots/a video to help users, as well as Project Managers to better visualize the issue and your idea. You may simply add them as a comment to your idea. 

Please let us know within the next two weeks.

Best regards,
Catalina 

May 22, 2025 11:44 AM UTC

I am adding a video that I hope will help understand what improvement I would make to the tool for sections in Creo Parametric.

Community Manager
May 22, 2025 3:10 PM UTC
Status changed to: Acknowledged

Thank you @Francesco_P for your idea. Based on the information you provided, we are acknowledging it as the Community management team. This is not a commitment from the Product team. Other users may comment and vote your idea up.

May 26, 2025 5:27 PM UTC

I fully agree.

When we need to create a planar section through a hole, it forces us to create a plane, or opt to create an offset cross-section instead, to be able to constraint the sketch over the axis of the hole.

There are workarounds, but more time consuming.

The possibility to create a planar cross-section paralell to a plane and through an axis or point reference would be a time saver.