Skip to main content
May 17, 2024 11:31 AM UTC
Acknowledged

Option for imported part features to be set to Read Only features by default

Related products:Creo Parametric

1. Are you using a workaround?
Yes, we are setting imported parts to read only one by one now.

2. What is the use case for your organization?
I was playing around with the new Creo 11 performance reporting (using Creo 9 in production) with an imported CCA. There were a couple of imported components that had complex geometry that was taking 4 seconds to regen. These components were patterned and Creo was performing a regen on each component each time and it was adding up to a lot. Setting the imported feature to read only changed the regen time to 0. In total, the Regen time for this CCA went from 1 min to 4 secs just by putting 3 imported geometry component features into read only mode.

3. What impact does this problem currently have on your organization?
This has a big impact on performance times for large assemblies.

Describe the Problem

Imported parts (step files) in general are not meant to be modified. The design authority for the geometry is controlled by the creator of the imported file. With this in mind it would be nice to have the option to put that geometry into read only mode by default. If it is imported geometry and isn't changing then there should be no reason to perform a regeneration on it. The example below is an ECAD part but I think this would be helpful in regular imported parts as well.

 

Go from this:

1.PNG

 

To this:

2.png

3 replies

olivierlp
Community Manager
May 17, 2024 12:13 PM UTC
Status changed to: Acknowledged

Thank you @Chris3 for your idea. Based on the information you provided, we are acknowledging it as the Community management team. This is not a commitment from the Product team. Other users may comment and vote your idea up.

Olivier
May 18, 2024 7:54 PM UTC

I think imported features are not regenerated by default. At least I have not notice any kind of excessive regeneration times with parts that have imported geometry features.

 

Could it be that yout template files have some kind of relations to calculate volume or part weight after regeneration? That way, even if geometry is not changed, perhaps Creo still makes the calculation after regenerating the remaining features after the imported geometry feature.

Chris3Author
Jun 4, 2024 3:46 PM UTC

No we do not have relations in our start parts