ModelCHECK "Required Relations" block capability
1. Describe the Problem
In Creo Parametric it can be helpful to have a common required block of relations to drive company standard attributes or calculations. For normal relations and comments ModelCHECK will only check for the existence of a relation or comment. There is no position check. (For solve blocks ModelCHECK does understand order dependance).
2. Are you using a workaround?
Manual Checking
3. What is the use case for your organization?
Checking of models prior to release for compliance to company standards.
I want the relations to look like
/*Begin Required Common Relations
CDA_CAGE_CODE=CAGE_CODE
/*Comment About Contract Number Should Be Below
CONTRACT_NUMBER=CONTRACT_IDENTIFIER
/*End Required Common Relations
But this will pass
/*Begin Required Common Relations
/*Comment About Contract Number Should Be Below
/*End Required Common Relations
CDA_CAGE_CODE=CAGE_CODE
/*Comment About Contract Number Should Be Below
CONTRACT_NUMBER=CONTRACT_IDENTIFIER
Using this configuration
PRT_COMMENT Begin Required Common Relations
PRT_RELATION CDA_CAGE_CODE=CAGE_CODE
PRT_COMMENT Comment About Contract Number Should Be Below
PRT_RELATION CONTRACT_NUMBER=CONTRACT_IDENTIFIER
PRT_COMMENT End Required Common Relations
Notes
1) I was also going to test the "RELATION_UPDATE_FILE", but I don't see a way to specify part vs assembly.
2) It would be good if the check would also report if there are additional copies of the lines in other parts of the relations. For instance has "/*End Required Common Relations" been repeated multiple times.
4. What impact does this problem currently have on your organization?
Currently manual checking steps are needed to ensure the correctness of the relations.
