Skip to main content
Feb 28, 2024 7:00 PM UTC
Archived

Manufacturing simulation and compare

Related products:Creo Parametric

1. What product and version are you running? 10.0.3.0


2. What is the problem? We save NC assemblies with the design model not shown. Running NC simulation with the design model not shown you can't run compare to verify the process with the original model. Once you start the simulation you can't show the design model after the fact. You have to start over. The problem is that on lengthy NC programs this can mean a lot of time and you may not always realize the design model isn't turned on. So at the end of the simulation you realize you can't run compare and have to start the process all over again. This can lead to a lot of wasted time.

 

It would be nice if either we could toggle the design model after running simulation or if Creo would ask if we would like to show the design model when we start a simulation for purposes of running Compare.

2 replies

Feb 29, 2024 9:15 AM UTC
Status changed to: Clarification Needed

Hi @dklimas!


Thank you for publishing your idea.


However, you give the bare minimum of information. The more details and context you give to document your idea, the better. Think about ways to educate and convince other Community members to support your idea and present your case to the product management team for consideration.

Here are a few examples of well documented ideas:

https://community.ptc.com/t5/Creo-Parametric-Ideas/Option-to-Import-STEP-file-as-Inseparable-Assembly-by-Default/idi-p/812924

https://community.ptc.com/t5/Creo-Parametric-Ideas/Eztol-Rename-action-not-synchronous-in-Eztol/idi-p/828000

https://community.ptc.com/t5/Creo-Parametric-Ideas/Always-enable-ability-to-Add-View-Label-in-a-drawing/idi-p/837630


Please elaborate within the next two weeks.

Additionally, I invite you to check out this topic where PTC executives explain product managers' approach to customer ideas and input for product roadmaps.

Mar 14, 2024 9:35 AM UTC
Status changed to: Archived

Hello,
We are following up on our request for additional information on your idea. In the absence of further comments from you, we are archiving your idea. You still have the option to post a new idea with all the details required.
Thank you.