Skip to main content
Dec 28, 2012 7:18 PM UTC
Acknowledged

Make Measurements reflect explode state values

Related products:Creo Parametric

Measurements should be capable of being captured in a way that includes the effect of explode state. Currently measuring between entities produces results that only refer back to the non-exploded location of components. It would be helpful for basic service procedure verification activitites if the measurements could be made on the exploded states in the 3D model rather than having to go to a drawing to take these measurements.

9 replies

Jun 2, 2017 2:21 PM UTC

Agreed, this NEEDS to happen. I can't could how many times I want to measure something while its exploded...only to have to go and create a drawing just to do it. I think everyone here at NyproMold agrees.

Jun 2, 2017 3:21 PM UTC

Yep I'm hoping it'll be in Creo 5 🙂

Jun 14, 2018 7:16 PM UTC
Status changed to: Acknowledged
Aug 15, 2022 11:33 AM UTC

This should also apply to annotations for a combination state that shows an explode state.

Mar 30, 2023 6:31 PM UTC

How many votes does this need before it gets implemented?

Mar 30, 2023 7:13 PM UTC

@dunebuggyjay Votes are in indication of community popularity but nothing else.There are many product ideas that have hundreds of votes.

The links below help explain how it works at PTC.

 

https://community.ptc.com/t5/Welcome-How-To-s/Community-Ideas-and-Product-Managers/m-p/759128

 

https://community.ptc.com/t5/Welcome-How-To-s/Getting-to-Know-PTC-Community-Ideas/td-p/607208

 

May 10, 2023 7:21 AM UTC

This would be very helpful.

In fact, I though at first that Creo did the thing and I almost made a very big mistake.

It would be very good, because in very large assembles, we could check instantaneously the different states of the assembly and beside that, we could perform measures to evaluate, how must the part should move from the current position, for example.

Family tables, are not a good solution. They take so much time for a small, but important check.

PTC, please add this feature to Creo.

Jul 25, 2024 8:39 AM UTC

Hi,

We need regulary to configure several position to our assembly.

We use also MBD and add annotations in the asm, and combinate states.

 

We are abliged to recreate manual dims in the drawing.

 

It is an issue because we pushed the draftmen to put all the dims in the 3D models, and add dims in the drawing must be an excepetion.

Please PTC add this feature in your next release version

Nov 3, 2025 6:08 PM UTC

Bringing this back to the top. Please vote for this. I've been waiting for 20 plus years for this to happen. Hell i'll probably be retired before I even see it implemented at this rate.