Skip to main content
Dec 20, 2012 8:46 AM UTC
Archived

It should be made possible to snap to construction lines on a workplane

Related products:Creo Parametric

At present it is only possible to snap to geometry lines on a workplane.

In order to snap to contruction lines it is necessary to convert them to geometry lines (or place geometry lines over them) first.

In order to avoid the need to abort a command in order to adjust the contents of a workplane before restarting the command, it should be made possible to snap to construction lines as well as to geometry lines on a workplane.

4 replies

Jan 2, 2013 9:54 PM UTC

Can you describe the situation where you can't snap to construction geometry? As far as I know, that capability has been in the product from the beginning (1.0).

Jan 3, 2013 7:13 AM UTC

You can move a part to being level with a geometry line on a workplane. Now try moving it to being level with a construction line on a workplane.

Jan 4, 2013 7:41 PM UTC

I see what you mean-if you Position Dynamically you cannot snap to a construction line, only a geometry line. You are right, this is a problem with the 3D Copilot. Using the 2 Points option instead of the 3D Copilot is a workaround, but I don't see any reason that you should not be able to snap to construction geometry.

Mar 16, 2019 2:07 AM UTC
Status changed to: Archived