Skip to main content
Dec 13, 2012 8:22 AM UTC
Archived

It should be made possible to create dimensions on open B-splines in Annotation

Related products:Creo Parametric

It is currently not possible to create dimensions on open B-splines in Annotation.

It is, however, possible to create 3D-dimensions on open B-splines in Modeling, which can then be transfered to Annotation via a documentation plane. Unfortunately this method does not allow you to transfer the center lines.

It should be made possible to create dimensions on open B-splines in Annotation.

6 replies

Dec 11, 2014 12:27 AM UTC

For me, most commonly tangential dimensions to B-Splines

Dec 11, 2014 12:37 AM UTC

Thank you Astrid for the workaround (transferring 3D Anno via docuplane).

Mar 5, 2015 5:11 PM UTC

How does this only have two votes? I regularly run into this limitation and it is really frustrating.

Also, why don't I see Astrid's comment anymore - did something break with the new community UI?

Mar 5, 2015 5:32 PM UTC

For me, this has never been an issue that I have run into-that's why I haven't voted for it.

Mar 5, 2015 5:48 PM UTC

In this example, I have had to split the spline at the peak of the tip and dimension 6.76 using a linear dimension, where I'd rather use a tangential dimension because I don't trust the split to stay through view updates. The other common place I have this problem is trying to give an overall length dimension of a non-prismatic part.

Mar 16, 2019 2:03 AM UTC
Status changed to: Archived