Skip to main content
Aug 13, 2014 6:54 PM UTC
Under Consideration

Improve Measure Tool

Related products:Creo Parametric

As-is, the dimension sometimes pops up behind the measure dialogue box, it would be better if it didn't so you wouldn't have to move the dialogue box to find the measurement.  Also, not having to hold the Ctrl key to select two items would be helpful.  Another enhancement would be to be able to escape the measure tool using the middle mouse button.

7 replies

Aug 14, 2014 12:13 PM UTC

I think it would also add a lot if the measure tool could also display by default:

Min Distance

Max Distance

X offest

Y offset

Z offset

Solidworks does this and it is extremely helpful.  Instead of having to pick which type of measurement output you want it just gives you everything by default and you can set it up to show this in both metric and english at the same time too.

Aug 14, 2014 8:52 PM UTC

we've seen users confused at measure for sure. i can't say i can think of a better solution than to throw away the need to use cntl key though.

May 19, 2015 3:33 PM UTC

Please allow the option to have the Wildfire 4.0 measuring tool because the CTRL button is not needed and the projected distances are displayed in different colors

Oct 28, 2016 9:32 AM UTC

The measure tool is awful.  As stated the dialog box is sometimes obstructed and the difficulty in finding orthogonal dimensions is ridiculous. 

Jun 14, 2018 6:32 PM UTC
Status changed to: Acknowledged
1-Visitor
Aug 18, 2020 7:54 PM UTC
Status changed to: Under Consideration

Improvement to the current measuring tool is under consideration.

 

Thank you for your input,

Todd Kraft

Creo Product Manager

Jan 15, 2025 10:36 AM UTC

It's been over 10 years since the start of this topic, Summary of mentioned requests:
- Dimension still pops up behind the measure dialog box sometimes.
- X Y Z offset measurement still involves manual calculation or using Projection multiple times (Delta XYZ is by default available in Inventor).
- Min distance is default setting
- Max distance can be toggled on (when in Distance mode, but not in Summary mode)
- Only advantage I see of the CTRL key, is that it allows you to select more than 2 references (e.g. if you'd need the area sum of multiple surfaces).
   Comparison: in Inventor you don't need CTRL, it just measures between the 2 last selected references. So selecting more than 2 references isn't possible, but I don't think there are many use-cases for that.