Hole Table Parameter changes should be alerted to the user.
1. Describe the Problem
When a hole file has been updated by the admin. The user should be notified when the edit a hole that some thing has changed. Currently, the parameters are updated without notifying the user of the change.
Case 1: We want to update the Fasterner_ID to a decimal format.
1) User gets a change order to change hole depth of an existing hole. Hole was 1/4-20 using the old hole file.
2) User opens part, edits the definition of the hole to modify the hole depth.
3) User OK's the edit
4) The hole fastener ID has been updated to .073-64 hole without alerting the user. (First hole in the detail file)
5) Hole information is incorrectly shown on design documents
Case 2: Administrator remove a legacy hole detail file from the load Point.
1) User gets a change order to change hole depth of an existing hole. Hole was 1/4-20 using the old hole file.
2) User opens part, edits the definition of the hole to modify the hole depth.
3) User OK's the edit
4) The hole fastener ID has been updated to 2-56 helicoil hole without alerting the user. (First hole of the first file in the load point) (Thread Type and Screw Size parameters changed without alerting the user)
5) Hole information is incorrectly shown on design documents. Design information has potentially be lost.
At a minimum Creo should recognize that Screw Size and/or Thread Type don't match what is currently in the load point. Then alert the user there has been a change. This could extend to other parameters such as clearance drill sizes.
Better would be that the warning could also suggest a new selection. IF the same thread type is available, THEN Creo could suggest the nearest size based on drill size.
Ideally, there could be some kind of replacement table that would pop-up. With the current parameters displayed, then the user could select different tables or sizes and get a real time comparison of the differences.
2. Are you using a workaround?
We are keeping old hole files in the HOLES load point so that legacy designs are less likely to be broken during an update.
3. What is the use case for your organization?
We want to update the hole detail files to be compliant with common standards and conventions. But when we update the FASTENER_ID or delete a hole file, then Creo will update some of the hole parameters without notifying the user.
4. What impact does this problem currently have on your organization?
This problem can lead to confusion or to drawing/design errors.
