Skip to main content
Jul 25, 2013 3:48 PM UTC
Archived

Highlighting capability when BOM table is spread accross multiple sheets

Related products:Creo Parametric

In some cases a BOM is paginate and spread across 2 sheets, or even completely placed on a seperate sheet - In such cases it is not possible to make use of the BOM/Balloon selection highlighting to enable quick identification of parts/sub-assemblies within the drawing interface.

I would be useful if the current selection highlighting capability for BOM/Baloons could be ehanced to allow for this.

1 reply

Mar 17, 2019 2:37 PM UTC
Status changed to: Archived