Faster component highlighting method (Global Interference results)
The current method of highlighting components by drawing the wireframe works well for small, simple parts but scales very poorly, and rapidly becomes extremely slow for larger parts, such as a cast gearbox casing for example.
Perhaps it's time to throw away the existing highlighting method (which seems to be entirely CPU-bound) and look for a faster, more efficient routine, maybe using the GPU?
A good use case is looking through the results of a Global Interference analysis. If the pair of components highlighted is, say, a nut and a bolt (where the thread volumes overlap) I can spin and manipulate the entire assembly easily and smoothly (5-10 fps, I estimate) to identify the location of the interference. If one of the components is the main gearbox casing, however, it can takes 6-10 seconds per redraw! It also seems to deal badly with a highlighted component extending outside the viewable area - this seems to slow it down more as you zoom in.
My system has a reasonably recent Xeon CPU with good single-thread performance, and a respectable NVidia Quadro graphics card - it should be more usable than this.
I've just checked with our test installation of Creo 4 (normally using Creo 3) and this is still no better, specifically in Global Interference. In both versions though, preselection highlighting and 'normal' selection highlighting is much faster...
