Skip to main content
Sep 27, 2016 2:26 PM UTC
Archived

Ensure Assembly is saved, even when there is a conflict with a submodel

Related products:Creo Parametric

When trying to Save an Assembly that has a WindChill Modification Conflict with a submodel, and then setting the Action to READ ONLY, the Assembly will not be saved initially. Saving the assembly again WILL work. This is critical as users think their work is being saved initially and then they end up losing everything if they close out of Creo without saving again. The small error message is not enough. There should be a use-case scenario within the software that saves the assembly even if a submodel is set to READ ONLY.


PTC says that this is a change in behavior and thus, this improvement idea is created!

4 replies

Sep 27, 2016 2:35 PM UTC

+100000000.

Dec 27, 2016 8:46 PM UTC

‌or a config option for a pop up instead of message whenever the top level object is not saved after any save action.

Jun 14, 2018 8:41 PM UTC
Status changed to: Acknowledged
olivierlp
Community Manager
Jan 4, 2022 5:08 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier