Skip to main content
Nov 27, 2018 10:46 AM UTC
Archived

Enable the check of locked Windchill-Parameters in ModelCheck (e.g. PTC_WM_LIFECYCLE_STATE)

Related products:Creo Parametric

To avoid or find out the use of 3D Creo-Models with certain Lifecyclestates (e.g. PROTOTYPE, INVALID) in large assemblies it would be fine when Modelcheck could check the content of a locked parameter that comes from Windchill.

 

Unfortunately Modelcheck is unable to check the content of locked Windchill-Parameters like PTC_WM_LIFECYCLE_STATE in the direct way.

 

Of course it is possible to go the indirect way and map the content of the locked Windchill-Parameter via a relation to a new Creo-Parameter. The new Creo-Parameter can be checked by ModelCheck and everthing workes fine. The problem is that the relation has to be added in every part, subassembly and assembly.

 

It would be fine to get the Lifecycle information direct from the locked Windchill-Parameter. In that case it would be sufficient just to show the content of the parameter (read-only). Changing the content should be functionality of Windchill as it is at the moment.

2 replies

Apr 25, 2019 6:43 PM UTC
Status changed to: Acknowledged
olivierlp
Community Manager
Jan 3, 2023 7:12 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier