Skip to main content
May 30, 2023 6:40 PM UTC
Acknowledged

Enable deletion of surface finish annotations in drawing mode

Related products:Creo Parametric

1. What version of the software are you running?
Creo 9.0.3


2. What is the problem?
Surface finish annotations cannot be deleted in Drawing mode, only in Part mode (MBD)... If someone makes an error while drafting and wants to delete the annotation, he has to go in part mode, show the annotation in MBD and then delete it. This is a significant decrease in productivity compared to previous versions of Creo and a source of confusion since the annotation can still be "deleted" in drawing mode but it will simply appear again using the show annotations command... There is no warning stating that the annotation has not really been deleted or anything... To the user, the surface finish annotation has been deleted, but then when you try to put a new one in place on the same surface, you get a warning in the message box that another surface finish is already applied on this surface. This situation has created a lot of frustration before the workaround was found (going in part mode).

3. Are you using a workaround? If yes, please describe it.
Deleting the surface finish annotation in part mode instead of drawing mode.

4. What is the use case for your organization? Describe how your idea would work in context or how it would apply to a practical situation.
Everyday use

5. What impact does this problem currently have on your organization? (Number of users affected, hours of lost productivity, etc.)
A lot of frustration and loss of productivity 

3 replies

May 30, 2023 7:15 PM UTC

Sounds like a training issue in the use of Creo 9 and the MBD tools.

If the surface finish is defined as part of an MBD definition in the part file, then in order to change it, you need to go the source of definition, which is in the part file. 

It also makes sense that the system would know about the surface finish definition and prevent someone from overriding it with some other value. The MBD surface finish is the controlling callout for both model and drawing mode.

sparadisAuthor
May 31, 2023 1:26 PM UTC

I'm talking about a surface finish annotation created in 2D drawing mode. Once created in 2D drawing mode, the surface finish annotation cannot be truly deleted in Drawing mode, which is confusing to say the least. 

I understand the idea of MBD and going this route in the future, but Creo should remain usable and efficient in 2D drawing... I'm not the first to find this frustrating : https://www.ptc.com/en/support/article/CS173609

olivierlp
Community Manager
May 31, 2023 6:27 PM UTC
Status changed to: Acknowledged

Thank you @sparadis for your idea. Based on the information you provided, we are acknowledging it as the Community management team. This is not a commitment from the Product team. Other users may comment and vote your idea up.

Olivier