Skip to main content
Sep 22, 2018 8:08 AM UTC
Archived

Dynamic time simulation can't simulate anti-vibration mounts !!!!

Related products:Creo Parametric

Hallo,

Every real vibrating system has anti-vibration mounts to isolate the system form ground.

Today there isn't any possibility to simulate this into Creo simulate. This is serius lack because the

vibrating system is strongly influenced from the elastic behavior of its mounts.

I suggest to implemet this by adding a two way spring table: today you can input the spring stiffness, and

the spring use the same value of the stiffness both in extension and compression condition.

It would be sufficient if it were possible to set two values of stiffness, one for compression, the other for extension

condition in order to simulate pre-loaded elastic supports.

1 reply

olivierlp
Community Manager
Oct 3, 2022 12:46 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier