Skip to main content
Jan 19, 2016 7:23 PM UTC
Archived

Dual Dimensioning Secondary Tolerance Rounding

Related products:Creo Parametric

Provide a config option or change  the standard to round the secondary unit tolerance before.pngafter.pngrather than truncating.

4 replies

Jan 19, 2016 9:03 PM UTC

You can vote for your own idea.

I will suggest that this was once discussed and PTC weighed in on the discussion.

If my take-away was correct, the idea that the metric equivalent would represent a value larger than the primary dimension tolerance value, this was not allowed.  So they err on the side of caution by reducing (always) the tolerance by truncating rather than rounding.

I am sure ASME has also discussed this and from what I remember, the implementation is in compliance with ASME recommendations.

Jan 19, 2016 9:17 PM UTC

Yes, that description of the background is correct, and the truncating is intentional.  The idea is a valid proposal, with a detail setup option as the user-configurable setting; it may be contrary to standard, but if enough people want it that way for their company, it could be done.

Jan 20, 2016 1:49 PM UTC

I agree that this should be a "configurable" option to ease/speed drawing preparation.

Regarding the dimensioning practice, so long as it follows ASME Y14.5 section 1.5

About rounding, this is also covered in section 1.6.4 acknowledging (1994) ANSI/IEEE 268 / (2009) IEEE/ASTM SI 10 rounding of US Customary linear units.

As I would make the understanding of the dimension shown, making the assumption that units are disclosed on the drawing (metric [inch]), that the secondary units are treated as reference and should not be used in the qualification for the feature and are provided as "information only"

my thoughts, for what they are worth

olivierlp
Community Manager
Jan 4, 2022 4:01 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier