Datum plane should stay parallel to first reference when second refence is an edge
1. Describe the Problem
When creating an offset plane, where you have selected an surface/plane to create the offset datum plane from as the first reference and then select and edge as the second reference, it jumps to the angled (offset) plane, and then you have to change it to parallel to get a parallel offset plane that is through the edge.
If the edge selected was a point it works fine and the plane stays parallel..
What would be nice:
If reference 1 is the edge and reference 2 is a plane/face it creates an angled plane.
If reference 1 is a plane/face and reference 2 is an edge it creates a parallel plane through the edge.
2. Are you using a workaround?
manually change the plane option from offset to parallel
3. What is the use case for your organization?
when creating a parallel plane through an edge reference
4. What impact does this problem currently have on your organization?
more clicks to make a plane
