Skip to main content
Jul 23, 2024 1:34 PM UTC
Acknowledged

countersink screws and patterns don't work as intended

Related products:Creo Parametric

1. Describe the Problem

There has to be a better way:  assemblies with countersink holes & flat head screws.

 

I have a hole pattern of countersink holes.

I assemble a flat head screw to this hole (shank to hole, tangent the hole surface to the screw taper.  it then want's a 3rd constraint.  I add a parallel constraint: plane to surface..)

 

I then pattern the screw, to follow the hole pattern

 

The screws then all follow some weird pattern.  They are all there; the dots show the proper placement, but the screws are all wonky.  Only the original is properly placed in its hole.  The others are all then floating in space, randomly..

 

(from what I remember this has always been a problem..)

 

Either fix the way the pattern function works with these type of constraints  (its the tangent constraint that causes this behavior..)

or

Fix / find a better way to constrain countersink holes & flat head screws..


2. Are you using a workaround?
constrain the hole to shank, then constrain screw head to surface. But this does not identify if the screw is proud or recessed on the part.. Easily allows for an interference..

3. What is the use case for your organization?
??

4. What impact does this problem currently have on your organization?
wastes time trying to figure out the cause.. holes may be the wrong size when the parts are made..

2 replies

Community Manager
Jul 23, 2024 1:44 PM UTC
Status changed to: Acknowledged

Thank you @pshepherdson for your idea. Based on the information you provided, we are acknowledging it as the Community management team. This is not a commitment from the Product team. Other users may comment and vote your idea up.

Jul 24, 2024 12:12 AM UTC

@pshepherdson 

 

The tangent constraint had some previous limitations that were solved in Creo 11.0.

But a simple way to fix this problem is to assemble the contersink screw with a "Centered" constraint instead of a tangent constraint.

To use the centered constraint you need to pick two conical surfaces, one on the hole, and one on the screw. If the cone have tha same angle, then automatically it becomes tangent and the patterns work as you intededed. If you use the "Centered" constraint you even don't need to align the cente axis of the screw with the center axis of the hole. You only need one constraint, and one pair of references. You only have to take care that the angle of the countersink in the hole is the same as in the screw, but in 99.999% of the cases it is a given.