Bolt Circle Center Mark
1. Describe the Problem
Creo does not allow you to create a bolt circle center marks within the drawing. A bolt circle pattern or feature has to be created using the hole feature, set as diametric, within the part file. If this feature is created using a diametric hole type in the part, then this will allow you to Annotate the bolt circle center marks properly in the drawing.
The issue is that most do not create a bolt circle pattern using the diameter type within the hole feature. Most are created using a sketch and then extruding material. Creo does not recognize the center point of and extrude, so center marks do not annotate.
2. Are you using a workaround?
Yes. A datum point has to be added to the sketch to get a center mark. The center mark only allows for a linear dimensions, not a diametric. To get a diametric center mark, you need to create a cosmetic sketch or create a sketch on the drawing. This is time consuming and unnecessary.
3. What is the use case for your organization?
Add a center Circular Center Mark button in the drawing. (Inventor and SolidWorks) both have one. The Circular Center Mark button will be in the Annotations Tab in a drawing. Once the button is selected, you select a diameter on your part and then each hole (or Feature) that pertains to that specific bolt circle.
4. What impact does this problem currently have on your organization?
Throughout the entire company this issue impacts at least 500 designers, costing ~83 hours a year in time lost doing work-arounds.
