Skip to main content
Jan 14, 2015 10:40 PM UTC
Archived

Better Support for removing 0 dimensions from model

Related products:Creo Parametric

Below are a few suggestions to help constrain the model better by removing unecessary 0 dimensions:

  1. Config option that defaults a constrain type for Mate/Align to coincident
  2. Sheetmetal Flat/Flange Feature: be able to constrain the ANGLE by Perpendicular, Parallel...
  3. Sheetmetal Flat Feature: be able to constrain the edge offset without going into the sketch to coincident

3 replies

Jan 15, 2015 2:15 PM UTC

for your #1, add the following config.pro option to always set mate/align to coincident

auto_constr_always_use_offset never

jwaghAuthor
Jan 15, 2015 2:26 PM UTC

Thanks Stephen! I asked somebody for PTC and they said there was no option. Ok. One down, two to go.

olivierlp
Community Manager
Jan 4, 2022 5:05 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier