Becoming Surface of Drafting Analisis Result
- 2 replies
- 302 views
To whom it may concern:
I am writing this e-mail to advise you to convert analsis result to surface.
Superpar is a suppler of the car manufacturer that generally deals with casting parts that many of them have complicated design. So, in order to be sure of the parting line for mold we often use draft anaysis. As you know, we can seperate positive or negative draft side under options -> model display in draft alaysis.
As you see in the picture below, i only selected positive draft (example) which is shown like surface. While i triying to design parts of the mold, i always need such a surface.
But, when i try to save as like a seperated surface, the Creo does not allow me.
My suggestion is allowing to create a surface of draft analsis results would be very useful for us and like us other mold designers.

Best Regards,
Mujdat ISIK
Senior Design Engineer & Project Leader
SUPERPAR OTOMOTIV SAN TIC A.S.
Izmir-TURKEY
