Skip to main content
Jul 23, 2024 5:15 PM UTC
Acknowledged

Add maximum X, Y, & Z interference value when calculating global volume or pair interference

Related products:Creo Parametric

1. Describe the Problem

MEX_MECH_R20_0-1721754557482.png

I can understand there is a 5.12mm3 interference, but I don't know how much is needed to move back in Y axis to avoid this, if that information was available, as a column display or right click on that row, that would be very useful.


2. Are you using a workaround?
Visually inspect and decide which direction need to find the interference amount, create a cross section & measure the distance.

3. What is the use case for your organization?
After detecting the interference, one typical action is to move the component away to avoid it. Having a max X, Y & Z value beside the volume would allow for a quicker solution implementation.

4. What impact does this problem currently have on your organization?
All users, adding several minutes to verify each interference.

2 replies

Jul 24, 2024 12:25 AM UTC

This might be difficult or almost impossible to implement.

The interference might not be "one sided". There might be volume interferening on both sides.

The interference algorithm is based on an analysis of small tetahedral mesh. (similar to triangulation of surfaces in 2D space, but using teatahedra or 3 sided pyramids in 3d space). You can have 50 tetahedron one one side of an axis oaverlapped and 2 teatrahedron on the other side, with non overalaped volume in the middle. The algorithm can calculate easily the interference volume, because it easily adds up the volume of each small tetahedron, which uses a simple formula. To achieve what you want, you would have to use or devise another kind of algoritmn, that would have to assume that the interferences would only be just "one sided", which is not the case in most situations, that's why a generic algorithm has to be used.

Community Manager
Jul 24, 2024 1:56 PM UTC
Status changed to: Acknowledged

Thank you @MEX_MECH_R20 for your idea. Based on the information you provided, we are acknowledging it as the Community management team. This is not a commitment from the Product team. Other users may comment and vote your idea up.