Skip to main content
Apr 4, 2013 5:45 AM UTC
Alternate Solution

A way to remove references in Creo that creates ghosts objects in PDMLink

Related products:Creo Parametric

After upgrading to PDMLink 10.1 (from 9) PDMLink more often creates ghosts objects to models no longer existing. Typically prt001.prt, prt0002.prt and so on (Probably a model that is temporary used in the assembly but removed or renamed). These models is not possible to find in the reference viewer, but they are still there so PDMLink can find them and therefore create problems during check in.  We need a diagnostic tool (in the reference viewer?) to find and remove unwanted references that creates ghost objects. Both in the models and the drawings. See PTC Case C11278174 that handle this problem and also TPI 137198 that is PTC:s current recommendation to remove ghosts objects from the drawing

12 replies

Jun 30, 2020 9:09 AM UTC
Status changed to: Alternate Solution

As mentioned in CS28858 , there is config option that can be used when required (dont have it always active)

Dec 18, 2020 10:49 AM UTC

The config option cannot be used with windchill because the options does only work when you load parts from hard drive not from your workspace. I tried to backup my drawing and reupload it to remove the references, which worked but Windchill detects that the parts are already available in the commonspace. I cannot upload and overwrite them. 

 

It is absolutely unintelligible that this issue is 10 years old (see issue reports on cad.net forum) and there is still no decent PTC solution for it! 

 

Why is there still no reference viewer for drawings with the ability to break unneeded references? (Right now we are using Creo 4.0 and Windchill 11.1)

 

The only dirty fix for me was to live with this faulty drawing reference and get rid of this ghost by uploading an empty prt with the same name.