Skip to main content
Dec 12, 2018 8:22 AM UTC
Archived

A line edge display is incorrect in drawing mode, if the assembly is partially interfering.

Related products:Creo Parametric

Article - CS71125
Hidden line edge display is incorrect in assembly and related drawing mode
for some edges while part display is OK in Creo Parametric
https://www.ptc.com/en/support/article?n=CS71125

We often make the assembly with intentionally interference because of the specifications of products.
It is very hard to eliminate all the interference in order to output the drawing.

3 replies

Dec 12, 2018 1:14 PM UTC

What version of Creo are you using? I haven't tested this on Creo 4 M060 yet. From what I understood from a few years ago when PTC was first trying to implement using multi-threading for hidden line removal on drawings that issue was a legacy of some prior efforts to improve drawing performance. What the developer I spoke with indicated at that time was that the multi-threading would require undoing some of those efforts and would therefore eliminate this hlr issue. You might check the latest builds of either Creo 4 or 5 and make sure the detail option is set to use the multi-threading.

Jan 10, 2019 5:09 AM UTC

I tested in Creo 4.0 M080 and Creo 5.0.3.0,  detail option "hlr_multithreading" is available for the drawing but it is not effective for this problem.

olivierlp
Community Manager
Jan 3, 2023 7:04 PM UTC
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.

Olivier