A cross-hatch profile should be mapped when a component is replaced in an assy
A cross-hatch profile in a drw will not map to a component that is replaced with another family table instance in an assembly. The profile will reset. This can cause issues by releasing a drawing that has the wrong x-hatch.
Response from PTC:
When a component is replaced with one of its family table instance, the ID of that component in the drawing will also change. As a result, the hatch profile property association cannot be maintained. As a result, the hatch pattern will be reset for the new component. This functionality is working as per current product specification.
If references are mapped during the replace, so should the cross-hatch. I almost didn't catch that the X-hatch practically disappeared on me!
