Skip to main content
Jul 9, 2010 8:04 PM UTC
Question

Sketch points in WF5.

In WF4 you could get sketch points which could be used in EMX to put in mutiple bolts or ej pins. Is there a way to sketch a group of points in WF5?

    1 reply

    Jul 9, 2010 10:27 PM UTC

    I am not sure I understand, but in WF5 in sketcher you can switch the points to geometric points. Then you could have a sketch with just points in it.

    Like this:

    points.jpg

    You change the point type here:

    changingpoints.jpg