Skip to main content
Jun 10, 2016 2:46 AM UTC
Question

not able to give zero angle in sketcher to the line?

zero_angle.JPG

not able to give zero angle in sketcher to the line?

    9 replies

    Jun 10, 2016 3:25 AM UTC

    That is true. I'd bet it's because the solver can't tell when the angle changes which way is positive.

    If a zero angle is required, I create a datum on the fly that has an angle and align geometry to that. It is tricky to make sure that a horizontal line doesn't get excess constraints. Watch for parallel/coincident-horizontal constraints being added by Intent Manager.

    Jun 10, 2016 5:53 AM UTC

    Thanks,that was very helpful.

    Jun 10, 2016 5:06 AM UTC

    Hi,

    in CR2 M070 I can set zero angle in Part mode. When I edit feature definition later, then Sketcher accepts zero value, too.

    MH

    Jun 10, 2016 5:52 AM UTC

    mine is student edition creo 2.0 m120.

    Jun 10, 2016 6:03 AM UTC

    you can give angle in another way

    Change to 90 deg..

    Jun 10, 2016 12:42 PM UTC

    Once you have completed your sketch try Edit instead of Edit Definition. For me trying to change the value in sketcher wouldn't change it but it would using Edit.

    Jun 11, 2016 4:28 AM UTC

    There are a number of other conditions where what a feature requires is at odds with what Intent Manager can deal with. I sometimes wish for a mode that allows Sketcher to access different dimensions than the feature has to prevent Intent manager from re-evaluating the solution it had that worked and replacing it with one that fails. It used to be more of a problem when slightly angled lines would be promoted to horizontal or vertical and required the sketch to be far from H or V and altered at the feature level.