Skip to main content
Jan 19, 2013 9:22 AM UTC
Question

how to flatten this in pro engineer?

hi,

how to flatten this in pro engineer (wildfire 4.0)?

gusset_flat.jpg

    5 replies

    Jan 20, 2013 2:17 AM UTC

    I think we need a little more information. Is it a sheetmetal part? You might also suppress the "knee" feature before flattening.

    Jan 20, 2013 3:44 AM UTC

    HI,

    yes it is a sheetmetal part....yes we can suppress it...but does it give the same result..then why should there be a flatten form feature...we can suppress..all the form features....

    Jan 20, 2013 4:11 AM UTC

    Sheetmetal is very dependent on how the part is built to allow flattening. What feature was the initial material?

    Maybe you can post the part file and we can look at it.