Skip to main content
May 21, 2010 5:44 AM UTC
Question

eDrawings for WF5?

Hi Folks,
We are gettinmg ready to change over to WF5 M040. One question is if
eDrawings will support WF5. Looking at the eDrawings site it sems that it
still only goes up to WF4. Anybody know anything different?


Regards, Brent Drysdale
Senior Mechanical Designer
Tait Radio Communications
New Zealand
DDI +64 3 358 1093
www.taitradio.com

    4 replies

    May 21, 2010 12:36 PM UTC
    Hi Brent,



    I just tried with both .drw and .prt and it doesn't work. I'm running
    version 10.2.0.122 of eDrawings.



    Regards,

    Fred


    May 21, 2010 1:19 PM UTC


    Just my opinion, but the 3D pdf that can be put out from WF4 and up makes EDrawings obsolete.


    Michael R. Jenkins P.E.
    Design Engineer
    Direct: 816-801-2332
    Fax: 816-891-9432

    Commercial Vehicle Systems
    Haldex Brake Products Corporation
    10930 North Pomona Avenue
    Kansas City, MO 64153-1215

    May 21, 2010 2:46 PM UTC


    We use Edrawings with WF5 M030/M040 and have no issues. Works very well in fact.

    Tim Wells
    In Reply to Brent Drysdale:

    Hi Folks,
    We are gettinmg ready to change over to WF5 M040. One question is if
    eDrawings will support WF5. Looking at the eDrawings site it sems that it
    still only goes up to WF4. Anybody know anything different?


    Regards, Brent Drysdale
    Senior Mechanical Designer
    Tait Radio Communications
    New Zealand
    DDI +64 3 358 1093
    www.taitradio.com
    May 26, 2010 9:22 AM UTC
    Hi Brent,

    We chaged to WF5 M030 2 weeks ago and are running eDrawing 2010 SP1 version 7.1 [7.1.0.107].
    Furthermore a installation of Microsoft C++ is needed. Free download from this link :