Skip to main content
Jul 24, 2024 1:55 PM UTC
Acknowledged

Prevent incorrect SheetMetal unfolding on the drawing

Related products:Creo Elements/Direct

1. Describe the Problem

Prevent incorrect unfolding on the drawing

 

The base area must be specified when creating the development. If the wrong part is clicked on by mistake, the wrong development will be on the drawing. If a DXF file is used for production, the wrong part will be delivered!

 

This article is already available
CS290414 - Flat view of a Sheet Metal part doesn't belong to the viewset in Annotation

 

This should be prevented. One variant would be that only the model with the active view set is displayed.
Perhaps there are even better solutions.

 

See also the attached file and video.


2. Are you using a workaround?
When creating the unfolding, it is important to pay close attention to which model is the right one for processing.

3. What is the use case for your organization?
There are always cases where the wrong processing is on a drawing. If DXF is now used for production, the wrong part is delivered! This results in higher production costs and delivery delays.

4. What impact does this problem currently have on your organization?
The error can occur for all users. We have not yet determined the exact error costs. However, this lies at several 10'000.- Euros

1 reply

Community Manager
Jul 24, 2024 2:01 PM UTC
Status changed to: Acknowledged

Thank you @sreinbold for your idea. Based on the information you provided, we are acknowledging it as the Community management team. This is not a commitment from the Product team. Other users may comment and vote your idea up.