Acknowledged
More Infos in Tooltip when pointing on machining feature
When moving the cursor over a machining feature the tooltip should show more information than only "PartThreadedBlindHole.5".
The tooltip should show some parameters of the feature, e.g. PartThreadedBlindHole.5 M6 TapDepth 12 Drilldepth 17
When the feature is member of a pattern also the parameters of the pattern should be shown, e.g. Radial Pattern Radius 25, Number 6, Total Angle 360°
When pointing on a threaded face the thread data should be shown, e.g. M8x1-LH

