Skip to main content
Sep 20, 2012 12:04 PM UTC
Alternate Solution

load model on cursor for easy positioning

Related products:Creo Elements/Direct

If you load a model and want to position this model in the assembly it often could be, that the loaded model is not visible, because it is located anywhere outside the viewing area. It would be better., if the loaded model is on the cursor and you can pick the position for the loaded model in the area, where you wanted to position it.

Look to Creo Parametric. If you want to insert a model into an assembly the model is on the cursor. It doesnot matter, what area is visible in the viewport.

3 replies

Jun 14, 2018 6:25 PM UTC
Status changed to: Acknowledged
Jun 26, 2020 3:00 PM UTC
Status changed to: Alternate Solution

The workflow requirement has been addressed by the "Position after Load" workflow enhancements in Creo E/D Modeling 20.2 & 20.3.

Please refer to https://support.ptc.com/help/creo/ced_modeling/r20.2.0.0/en/#page/ced_modeling%2FOSDM_Main%2Fwhatsnew_modeling.html%23wwID0E6M6HB for the What's new information.

 

P.S. this idea has been moved to the Creo Elements/Direct ideas section.

Oct 30, 2022 10:53 AM UTC

Hello,

Yes, I see that this is older, but I would like to give a tip to the users of the older versions as well. 😁
Just check the option in the loading dialog as shown in the picture, then the part hangs on the polestar an can be positionned.

 

FriedhelmK_0-1667126695162.png

Best regards and success