Skip to main content
sept. 18, 2017 5:12 PM UTC
Question

Module Works and Creo functionality

With the change over to Module Works and the loss of Vericut, no longer does the material removal simulation open in a second window allowing the simulation to run while still working in a ProE/Creo session.

Our output has been drastically reduced as some of our simulations take several hours to complete.

A support case was opened to determine if this was somehow even possible.

Support stated this is not possible and to submit a product idea to see if the community thought it was valuable enough.

The idea is to allow a simultaneous or concurrent session of Creo so design can continue while Moduleworks is running the simulation in a seperate process.

Hopefully this is something that others could benefit from as well so vote early and often.

 

 

2 commentaires

sept. 18, 2017 5:47 PM UTC

@ZPeter

You need to put "idea" here https://community.ptc.com/t5/Creo-Ideas/idb-p/CreoIdeas

The area you posted in "community issues" is for problems with the ptc community forum, not the software.

 

Jaime Lee will move this post but it won't be an "idea". You'll have to remake in the ideas area (link above)

 

@Jaime_Lee, please move this to https://community.ptc.com/t5/Additional-Creo-Questions/bd-p/OtherCreoTopics

 

 

sept. 21, 2017 11:26 AM UTC

Hi,

 

for some time Creo license code contains DUP_GROUP=UHD keyword. This enables user to launch Creo using the same floating license several times on his computer and consume 1 license, only. Therefore you can launch two Creo sessions - one for ModuleWorks analysis and one for continuous work.