Skip to main content
Nov 26, 2013 7:51 PM UTC
Question

Sheetmetal Corner Relief - Circular - Creo Parametric 2.0 M070

Does anyone know how to make a circular corner relief using the sheetmetal functions? PTC support stated that you cannot make this type of relief in sheetmetal that has and extruded rectangular cut-out as shown below. The help center states to rip then make the relief. The corner, circled in red, will not allow a rip or relief. Any suggestions on how to make this work?

corner_relief.jpg

    1 reply

    Nov 26, 2013 8:00 PM UTC

    Hey Steven, I believe those are used for relief on corners.