Skip to main content
3-Newcomer
Apr 18, 2016 12:39 PM UTC

I think you're over thinking  it.  I made it with a single extruded wall and an extruded cut.  It's not a complex bend, it's just trimmed through the radius.  Green below is my part overlaid on top of both of yours.

Capture.JPG

1 reply

3-Newcomer
Apr 18, 2016 12:39 PM UTC

I think you're over thinking  it.  I made it with a single extruded wall and an extruded cut.  It's not a complex bend, it's just trimmed through the radius.  Green below is my part overlaid on top of both of yours.

Capture.JPG