Skip to main content
Feb 3, 2014 3:07 AM UTC
Question

Re: Wind Turbine with Spline Points

Hi Ryan,

Create a surface feature with a curve through the points and make sure you have a closed loop.

Extrude the surface to the desired length.

Use the fill feature to fill in the ends of the blade.

Merge the surfaces together.

Solidify to make a solid part.

Or you could just use the extrusion tool, sketch a spline through the points and extrude the blade as a solid.

Can you upload the file?

    9 replies

    Feb 3, 2014 7:40 AM UTC

    Some time ago we developed a wind turbine project for middle and high schools and created the airfoil section blades using two modelling strategies.

    1. An extruded airfoil section created a solid parallel blade. The twist tool in Warp altered the angle of attack along the length of the blade and a chamfer applied taper to the blade.

    2. The Swept blend tool (loft) was used to connect a series of parallel section sketches. Each section can be rotated to determine the amount of twist in the blade.

    Both blade models are attached.

    Airfoil_twist_375x480.png

    Feb 3, 2014 8:09 AM UTC

    I'm sorry but I don't understand "Create a surface feature with a curve through the points and make sure you have a closed loop."

    Will upload the other splines in the next post.

    Feb 3, 2014 1:37 PM UTC

    Hi Ryan,

    I made one section of your turbine, from plane 1 to plane 2, and I attached the model. I don't know the distance between your planes. You can look at the model tree and see how I did it, and then you can apply this method to the whole blade.

    I don't know how much capability you have with your software, but I used the Boundary Blend tool to connect the curves together with surfaces, filled the ends with the Fill function, Merged, then Solidify to make a solid part. See if this works for you. If you want the entire blade, I will need the distances between all the planes.

    wind_turbine.jpg