Skip to main content
May 14, 2014 2:16 PM UTC
Question

Re: Using Fasteners - Creo Simulate

Here's how you can change that. If you want N for Newtons in your measure definition, change your model properties. Go to:

File>Prepare>Model Properties>Units

Select and Set to (MKS) or (mmNs) as show below. I think you must have selected (mmKs), and this will give you the mmkg/sec^2 for Force in the Measure Definition. You can include Subcomponents under the Info tab.

units_N_measures.jpg

    1 reply

    May 14, 2014 5:33 PM UTC

    Thank you very much for the help Steven.