Skip to main content
May 14, 2014 12:39 PM UTC
Question

Re: Using Fasteners - Creo Simulate

It sounds like you have already figured out this particular problem in the model. If you're working with SI units, then of course, your force should be in Newtons, as shown below. I don't work with SI, but I quickly converted my units to MKS, and I got the right units for Force in the Measure Definition window.

defined_measures_force_newtons.jpg

    1 reply

    May 14, 2014 12:56 PM UTC

    Yes, the worry about having two different unit in the same result window I found out what was wrong.

    The only difference that I see is that your CREO shows directly the unit as N (Newtons), but mine shows mmkg/sec^2 (milliNewtons). And I can't or don't know how to change that.