Skip to main content
May 14, 2014 10:56 AM UTC
Question

Re: Using Fasteners - Creo Simulate

Guilherme,

It appears that you have some Measures that were defined and they are called:

placaII_axial

placaI_axial

and I don't know what units were selected for the Measures.

    1 reply

    May 14, 2014 12:07 PM UTC

    Hi Steven,

    I selected force as "quantity" and the units I think that I'm not able to change them, they're at the default kg/mm/sec^2 (please see picture).

    But the problem was that the configuration of the model was not correct.Simulate_Measure.jpg