Skip to main content
May 8, 2014 11:25 AM UTC
Question

Re: Using Fasteners - Creo Simulate

Hi Guilherme,

One thing I might add to this discussion is the use of preloaded fasteners due to wrench torque. I’ve attached a document to illustrate how to use the preload. It’s for WF4, but it will work in Creo 2.0. This is one area that’s overlooked, and there’s not much documentation out there to tell you how to use preloads.

I highly recommend reading and working the example in the attached document so you may become familiar on how to obtain the right preload for fasteners. You have to make two runs in Simulate in order to accomplish this, yes, even with Creo 2.0. I think this will change for Creo 3.0.

I’ve attached another document that explains infinite friction, along with other Mechanica contact theory, and this is really used to indicate slippage. It’s called “friction” in WF4, but when you enable infinite friction, the elements actually bond together. This is still the same for Creo 2.0.

I have always turned the Fix Separation off and placed contacts between bodies. When you enable Fix Separation, the edges around the holes will bond, and when you deform the model, you will see where the edges are “glued”. But it depends on what your region of interest it.

    2 replies

    May 13, 2014 2:32 PM UTC

    Hi Steven,

    thank you very much for the contribution for the discussion and for the material that you shared with us.

    I was running some tests for the fasteners (how to set the correct pre-load) and found measures in the "Run Status Display" with two different units, please see image.

    How the custom system units are set to: Length: mm, Mass: kg, Time: sec. I've assumed that the unit for the forces displayed were in mN (N e-3) and I also confirmed that with some tests (in the image setting a load of 500 N and having the result as 5.0e+5). But for Fastener_axial_force the result 2.0255e+4 is probably directly in Newtons because the pre-load that I was inputting was 20 kN (corrected by the formula presented in your pdf).

    Am I missing anything?

    Simulate_Fastener.jpg

    Best Regards,

    Guilherme

    May 13, 2014 6:06 PM UTC

    Sorry guys,

    I found out that the model wasn't considering contact between the plates and the FIX SEPARATION was turn off as well.

    Sorry for that.

    Best regards,

    Guilherme