Skip to main content
Jun 27, 2014 11:25 AM UTC
Question

Re: Torque and centrifugal loads

Hi Jordan,

Could you add the other components to your part to help facilitate visualization? It appears that you have a mechanical input of 4000 rpm on a sprocket on one end of the air plug. Is the bearing on the right side pressed into the sprocket or is the sprocket mounted separately to the shaft? The shaft is longer on the right side as compared to the left side. Both ends have a bearing which allow rotation of the plug, but then you have a sprocket attached somewhere. Correct? Do you want the part to rotate in the simulation? This problem statement is a little confusing to me, because you want to “block” rotation, but in reality the part is not “blocked”?

Welcome to the forum.