Skip to main content
Sep 2, 2014 8:50 PM UTC
Question

Re: Thin plate + contact

The below pipe was meshed with auto-controls. I didn't use any "guide lines" to make the mesh.

brick_mesh_04.jpg

brick_mesh_05.jpg

brick_mesh_02.jpg

    1 reply

    Sep 2, 2014 9:31 PM UTC

    for simple geometry, what I call "guide lines" are not necessary because you use the same geometry as guide for the costraction of the mesh.

    Instead if the geometry are more complicated you need points and lines "inside" the geometry.

    Try to mesh my assembly with "mapped mesh"; maybe I'm wrong.