Skip to main content
Aug 28, 2014 7:15 PM UTC
Question

Re: Thin plate + contact

Try running the model with no shells, and no surface regions, as shown below. I just ran a quick check with no poblem using solid elements, but different load. I did add some material to represent a weld. I'm running Creo 3.0, and I didn't account for stiffness for the bolts. Just make your model simple to start with to make sure it will run.

model.jpg

mesh.jpg

displacement.jpg

    1 reply

    Aug 29, 2014 7:37 AM UTC

    Thanks Steven, but my goal is to learn the right manner to use the new tools for meshing that Creo 2 gives compared to WF5.

    Is more for knowledge that for work.