Skip to main content
Nov 25, 2014 3:47 PM UTC
Question

Re: Stress in joint through prestressed bolt

Andreas,

I built this in Creo 3.0, so you won't be able to open it, but I posted the image. It's very simple, and I was only experimenting with your model. Here's what I did:

  • Modeled 1/4 of the assembly
  • Applied symmetry constraints to both sides
  • Placed three frictionless contacts
  • Removed the contacts between the shank and bore
  • Constrained one end of the bolt
  • Applied 1/4 of the preload
  • Applied 1/4 of the cross-sectional area for preload

I was going to run this over again with an advanced fastener, but I just haven't had the time.

preload_01.jpg