Re: Slicing solid model to sketch inside it
First of all, I wouldn't use a cut surface as a reference, and that's what you're asking Creo to do. It's a better practice to model off real datum planes. You want to be able to "slice" the model while in sketcher and use the surface that was created from the "slice". Right? And then you will "unslice" the model in sketcher to continuing with modeling? Inventor/Solidworks must have some built in function where you sketch on this "sliced" plane and it's reference to a plane and not the actual part surface, I assume this. What happens if you try to modify the part later and you find out that you can't modify it because a dimension is referenced to this "sliced" plane? I haven't seen this in Creo, but it sounds like a nice feature to have, as long as it acts independent.
