Skip to main content
May 26, 2014 2:45 AM UTC
Question

Re: Sketching a heatsink profile for extrusion

Just make the holes after the pattern.

    1 reply

    May 26, 2014 10:26 AM UTC

    Thanks, it seems to work OK.

    I can create a fin, pattern it.

    Then add another sketch on the end of the pattern and extrude that

    Then add the "ends" of the heatsink touching the start of the patterned fin and the second "extension" bit.

    A multistep process, but quite quick to do and it works.

    My fear of being unable to then add holes on the base because the base is made of multiple surfaces "stitched together" is unfounded, the whole base is then seen as a single surface on which I can add my holes