Skip to main content
Mar 30, 2015 12:30 PM UTC
Question

Re: Sketch setup on Sweep

Lucas,

The Sketch Setup is greyed out (shown below) because the trajectory drives the sweep. If you change the direction of the curve (trajectory), it will change the direction of the sweep.

sweep_01.jpg

sweep_02.jpg


    3 replies

    Mar 30, 2015 4:36 PM UTC

    To change the direction I should click on the red arrow ?

    If I do so, it fixes the "upside down" part of the problem, but not the "all twisted", or with the camera turning 90 degrees (I didn't describe before, but that's what I'm facing in my current part)

    I ask PTC: Why the heck sketch setup is disabled !?

    Evidently, the sketch plane is pre-defined. I don't need to change that. But the inability to change the reference plane is ridiculous.

    3-Newcomer
    Mar 30, 2015 5:59 PM UTC

    In your simple sweep, it can be a bit hard to understand why, but the VSS tool really needs to have the sketch orientation determined by the sweep tool. On more complex sweeps the sketch orientation may actually change throughout the sweep.

    Mar 30, 2015 6:16 PM UTC

    Hard to understand why.

    True

    You may be implying that it's not just a "camera" issue, right ?

    I remember fussing around on a more complex sweep once. Changing little things gave result (different angles of view), but I could not understand them, and they would still make it hard to draw.